90 degree Elbow for 27mm Galvanised Pipe Treated Baluster Most commonly used with types

Most commonly used with types 101 and 125 to mount sloping rails onto vertical uprights

This fitting will work with horizontal galvanised pipe (tube) of an outside diameter of approximately 60mm

Fixing holes suit a wide range of common mechanical and chemical masonry anchors

often used where top rail meets corner upright on level sites

As a decorative corner piece (between a post and facia board)

90 degree Elbow for 27mm Galvanised Pipe Treated Baluster Most commonly used with typesWhere would you normally use this galvanised pipe fitting? The 125 is a 90 degree angle joint, often used where top rail meets end upright on level sites. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 27mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to exceed the requirements of AS NZS 4680: 2006, giving a